/OPEN Command

The /OPEN command restores access to terminals or line groups by the CA Workload Automation SE system after a /CLOSE command.

Use this command to start manually the following interfaces:

The CA Workload Automation SE CAICCI terminal interface
The CA Workload Automation SE TCP/IP terminal interface

You sometimes must start the CAICCI terminal interface manually for one of the following reasons:

CAICCI is not active when CA Workload Automation SE initializes.
CAICCI terminates after the interface has initialized.

To initialize the CA Workload Automation SE CAICCI terminal interface without recycling CA Workload Automation SE, use the /OPEN command specifying a GROUP that is defined as DEVICE=CCI. You do not need to issue the /OPEN for each group that is defined with DEVICE=CCI. One /OPEN issued for any such group suffices.

Do not use this command after a /CLOSE has been issued for a GROUP defined as DEVICE=CCI.

If one of the following situations occurs, you sometimes must start the TCP/IP terminal interface manually:

TCP/IP was not active when CA Workload Automation SE was initialized.
TCP/IP has crashed.
The TCP/IP terminal interface was shut down with a /CLOSE command.

You can initialize the TCP/IP terminal interface without recycling CA Workload Automation SE. Use the /OPEN command specifying any GROUP that is defined as DEVICE=CCI and the TERM=TCP/IP parameter. You do not need to issue the /OPEN for each group that is defined with DEVICE=CCI. One /OPEN issued for any such group suffices.