Installing Your Product from Pax-Enhanced ESD › Receive the SMP/E Package › Prepare the SMP/E Environment For Pax Installation

Prepare the SMP/E Environment For Pax Installation

The members that are used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA Vtape.

For information about the members, see the comments in the JCL.

Follow these steps:

1. Customize the macro SVTSEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE command. Each time you edit an installation member, type SVTSEDIT on the command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize the yourHLQ.SAMPJCL members.

   Note: Set the DASD HLQ to the same value specified for yourHLQ for the unzip to DASD ESD JCL.

   Note: The following steps include instructions to execute the SVTSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the SVTEDALL member.

2. Open the SAMPJCL member SVT1ALL in an edit session and execute the SVTSEDIT macro from the command line.

   SVT1ALL is customized.

3. Submit SVT1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA Vtape are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. Open the SAMPJCL member SVT2CSI in an edit session and execute the SVTSEDIT macro from the command line.

   SVT2CSI is customized.

5. Submit SVT2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.