The Parameter Library (PARMLIB) › VTP2PRMT Parmlib Member

VTP2PRMT Parmlib Member

Note: Remote Virtual Tape requires a separate CA P2P license.

VTP2PRMT is a parmlib member containing the Peer To Peer Remotes section. This section describes attributes used for defining TCP/IP parameters of RemoteSystems.

These attributes specify characteristics for RemoteSystems like the TCP/IP IP address and port number used to communicate with those remote systems. Each remote must have a unique RemoteSystem name, ConsoleSuffix, and IP:Port address combination. The CA Vtape P2P Listener will only accept or establish connection with those systems identified within this list.

While active, the CA Vtape subsystem can dynamically reload the <PeerToPeerRemotes> section attributes using the SVTn REFRESH=REMOTES console command.

Since the RemoteSystem definitions are local definitions that are subsystem specific, the SVTn REFRESH=REMOTES console command must be issued for each CA Vtape subsystem sharing a common VTP2PRMT member that has been modified. If this is not done, then only the CA Vtape subsystem which issued the command will pick up the changes.

The SVTn REFRESH=REMOTES console command should be executed when there are no active remote connections active. Active connections will not be refreshed and the previous attributes will continue in effect until the connection is closed.