![Previous Topic: Management System Not Receiving SNMP Trap Messages](574.png)
![Next Topic: Verify that the Agent is Sending Traps](573.png)
CA SystemEDGE User Guide › Troubleshooting and Usage Suggestions › Common Problems and Questions › Management System Not Receiving SNMP Trap Messages › Verify Agent Trap Configuration
Verify Agent Trap Configuration
To verify that the agent is configured to send trap messages to the appropriate addresses, do one of the following:
- For SNMPv1, verify the trap communities in the sysedge.cf file.
- For SNMPv3, verify the USM security configuration in the sysedgeV3.cf file.
- On UNIX systems, verify the trap communities in the sysedge.cf file. For example, make sure that only one IP address is specified for each trap community statement. For more information about trap community configuration, see the chapter “Agent Configuration.”
- On Windows systems, verify the trap configuration (SNMPv1 only) through the Control Panel application. For more information, see Configure Access Communities in the chapter “Agent Configuration.”
Copyright © 2013 CA.
All rights reserved.
![Previous Topic: Management System Not Receiving SNMP Trap Messages](574.png) ![Next Topic: Verify that the Agent is Sending Traps](573.png)
|
|