Installation Steps to Upgrade to Version12.0

Migration Information › Upgrading from Release 11.7, r11.6, r11.5, and r11 › Installation Steps to Upgrade to Version12.0

Installation Steps to Upgrade to Version12.0

To upgrade to Version 12.0, perform each installation step exactly as presented in either of the three "Installation" chapters unless the step has upgrade instructions in the table that follows.

The Step column lists the step and the Upgrade Instructions column explains what you must do if the step needs to be modified or replaced.

Installation Step	Supplementary Upgrade Instructions
Step BRM1ALL	Comment out or delete the allocations for the target libraries that exist. Note: Beginning with release r11, to help simplify installations and upgrades, the foreign language panel FMIDs have been incorporated into the CA View base FMID. This change requires that all four panel libraries exist or the apply step will fail. Also, it is likely that any existing panel libraries must be enlarged before you run the Apply step. See the Hardware Requirements section to determine the amount of space required for these libraries and adjust accordingly. If you are upgrading from r11.7, and the panel libraries are sufficiently allocated, skip this step.
Step BRM2CSI	Comment out or delete the allocations for any libraries that already exist. Comment out or delete the step that creates the CSI. Change all ADD statements to REP statements. If you are upgrading from r11.7, skip this step. Note: The default middle level qualifier name of the SMP/E CSI has been removed beginning with release r11.6. If upgrading from a previous release, ensure that the correct, complete name of your CSI is specified in the PARM= on the execute card.
Steps BRM3RECD or BRM3RECT, BRM4APP, BRM5ACC	No supplementary instructions. However, be aware that the default middle level qualifier name of the SMP/E CSI has been removed beginning with release r11.6. If upgrading from a previous release, ensure that the correct, complete name of your CSI is specified in the PARM= on the execute card.

Installation Step

Supplementary Upgrade Instructions

Step BRM1ALL

Comment out or delete the allocations for the target libraries that exist.

Note: Beginning with release r11, to help simplify installations and upgrades, the foreign language panel FMIDs have been incorporated into the CA View base FMID. This change requires that all four panel libraries exist or the apply step will fail.

Also, it is likely that any existing panel libraries must be enlarged before you run the Apply step. See the Hardware Requirements section to determine the amount of space required for these libraries and adjust accordingly. If you are upgrading from r11.7, and the panel libraries are sufficiently allocated, skip this step.

Step BRM2CSI

Comment out or delete the allocations for any libraries that already exist. Comment out or delete the step that creates the CSI. Change all ADD statements to REP statements. If you are upgrading from r11.7, skip this step.

Note: The default middle level qualifier name of the SMP/E CSI has been removed beginning with release r11.6. If upgrading from a previous release, ensure that the correct, complete name of your CSI is specified in the PARM= on the execute card.

Steps BRM3RECD or BRM3RECT, BRM4APP, BRM5ACC

No supplementary instructions.

However, be aware that the default middle level qualifier name of the SMP/E CSI has been removed beginning with release r11.6. If upgrading from a previous release, ensure that the correct, complete name of your CSI is specified in the PARM= on the execute card.