Installation Steps for Upgrading to Version 12.0

Migration Information › Upgrading from CA Deliver Release 11.5, Release 11.6, and Release 11.7 › Installation Steps for Upgrading to Version 12.0

Installation Steps for Upgrading to Version 12.0

To upgrade to Version 12.0, you must perform each installation step exactly as it is presented in the appropriate Installation chapter, unless the step has upgrade instructions in the table that follows.

The Step column lists the installation step in the chapter "Installation" and the Upgrade Instructions column explains what you must do if the step needs to be modified or replaced.

Installation Step	Supplementary Upgrade Instructions
Step BRN1ALL	Comment out or delete the allocations for any existing libraries. If you are upgrading from r11.7, and the panel libraries are sufficiently allocated, skip this step.
Step BRN2CSI	Comment out or delete the allocations for any existing libraries. Comment out or delete the step that creates the CSI. Change all ADD statements to REP statements. If you are upgrading from r11.7, skip this step. Note: The default middle level qualifier name of the SMP/E CSI has been removed beginning with release r11.6. If you are upgrading from a previous release, be sure that the correct, complete name of your CSI is specified in the PARM= value on the execute card.
Step BRN3RECD or BRN3RECT, BRN4APP, BRN5ACC	No supplementary instructions. Note: Be aware that the default middle level qualifier name of the SMP/E CSI has been removed beginning with release r11.6. If you are upgrading from a previous release, be sure that the correct, complete name of your CSI is specified in the PARM= value on the execute card.

Installation Step

Supplementary Upgrade Instructions

Step BRN1ALL

Comment out or delete the allocations for any existing libraries. If you are upgrading from r11.7, and the panel libraries are sufficiently allocated, skip this step.

Step BRN2CSI

Comment out or delete the allocations for any existing libraries.
Comment out or delete the step that creates the CSI.
Change all ADD statements to REP statements.
If you are upgrading from r11.7, skip this step.
Note: The default middle level qualifier name of the SMP/E CSI has been removed beginning with release r11.6.

If you are upgrading from a previous release, be sure that the correct, complete name of your CSI is specified in the PARM= value on the execute card.

Step BRN3RECD or BRN3RECT, BRN4APP, BRN5ACC

No supplementary instructions.

Note: Be aware that the default middle level qualifier name of the SMP/E CSI has been removed beginning with release r11.6.

If you are upgrading from a previous release, be sure that the correct, complete name of your CSI is specified in the PARM= value on the execute card.