Installing Your Product from Pax-Enhanced ESD › Receive the SMP/E Package › Prepare the SMP/E Environment for Pax Installation

Prepare the SMP/E Environment for Pax Installation

The members used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA Deliver.

Prior to beginning this procedure, confirm whether your product uses UNIX System Services (USS). If it does, establishing a hierarchical file system (HFS) may be required as part of the product installation or required as a feature of the product.

For information about the members, see the comments in the JCL.

Follow these steps:

1. Customize the macro BRNSEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE macro command. Each time you edit an installation member, type BRNSEDIT on the TSO command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize the yourHLQ.SAMPJCL members.

   Note: Set the DASD HLQ to the same value specified for yourHLQ for the unzip to DASD ESD JCL.

   Note: The following steps include instructions to execute the BRNSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the BRNEDALL member.

2. Open the SAMPJCL member BRN1ALL in an edit session and execute the BRNSEDIT macro from the command line.

   BRN1ALL is customized.

   Note: When upgrading into an existing CSI, comment out any allocation DD statements for existing files.

3. Submit BRN1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA Deliver are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. If your product requires HFS or if you want to install a feature of the product that requires HFS, complete the following substeps:
   1. Open the SAMPJCL member ccc1ALLU in an edit session and execute the BRNSEDIT macro from the command line.

      Note: All instances of ccc in this section indicate a three-character component code based on the FMID.

      ccc1ALLU is customized.

   2. Submit ccc1ALLU.

      This job allocates your HFS data sets.

   3. Open the SAMPJCL member ccc2MKD in an edit session and execute the BRNSEDIT macro from the command line.

      ccc2MKD is customized.

   4. Submit ccc2MKD.

      This job creates all directories and mounts the file system.

5. Open the SAMPJCL member BRN2CSI in an edit session and execute the BRNSEDIT macro from the command line.

   BRN2CSI is customized.

   Note: When upgrading into an existing CSI, comment out any allocation DD statements for existing files and delete the CREATCSI step. Change all ADD’s to REP’s.

6. Submit BRN2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.

     The DDDEFs for the required SMP/E data sets are created.

7. If your product requires HFS or if you want to install a feature of the product that requires HFS, complete the following substeps:
   1. Open the SAMPJCL member ccc3CSIU in an edit session and execute the BRNSEDIT macro from the command line.

      ccc3CSIU is customized.

   2. Submit ccc3CSIU.

      This job customizes the CSI by adding the DDDEFs associated with the directory.