Introduction › Commands › System-Wide Commands › JUMP Function

JUMP Function

The JUMP function allows you to jump from one screen to another, bypassing the Primary Selection panel and intermediate panels.

To issue a jump request from any CA View menu, enter an equal sign followed by any command that is valid on the Primary Selection panel.

Note: Enter this information on the command line.

Example

To display a SYSOUT selection list for all generations of SYSOUT from any CA View menu, you can immediately jump through the Primary Selection panel and issue a SYSOUT Selection ALL command with the following command:

COMMAND ===> =s all

The result is the same as if you:

• Repeatedly entered END commands through all intermediate menus until the Primary Selection panel was displayed.
• Entered the SYSOUT selection command ALL.