EMC Centera Disk Option › Configuring the Centera Access Server › Implementing the Centera Access Server › NTHREADS=n

NTHREADS=n

NTHREADS=n specifies the number of report processing threads for the primary or only server.

Be aware of the following:

• This number can be changed dynamically but it can never exceed the initial value specified on this parameter.
• The parameter is not required for a secondary server.
• Each processing thread can allocate one report. Be sure to specify the maximum number of reports you would like to have available before users have to wait for a thread to reach MINIDLE.
• Each active thread will cause a connection to the Centera server.

Note: For performance reasons, this parameter should be set to a number equal to (20 * number of IP Addresses). This value is the number of IP addresses specified in the CENTADR= initialization parameter.

The default is 20.