Using the Optical Disk Interface › Kodak Optistar Drivers › Retrieving SYSOUT Data from Optical Disk (Report-Level Driver Only)

Retrieving SYSOUT Data from Optical Disk (Report-Level Driver Only)

• If Your TSO User ID Has MOUNT Authority

  When you select a SYSOUT group that shows a status of DSK2, PDK2, or PRM2 (all of which indicate optical disk secondary storage), CA View reloads the entire SYSOUT from optical disk back into the CA View database.

  Note: DSK2, PDK2, or PRM2 all indicate optical disk secondary storage.

  You can explicitly request that the SYSOUT group be loaded back to the primary disk database. Use the L line command online or the /LOAD function when you are executing in batch using SARBCH.

• If Your TSO User ID Does Not Have MOUNT Authority

  You must use the L line command online or the /LOAD function when executing in batch using SARBCH.

  After the SYSOUT group is retrieved, it continues to reside in the CA View database (as well as on optical disk storage) until the backup cycle specified by the HOLDTEMP initialization parameter occurs.

  You can remove the SYSOUT group from the CA View database before the next backup cycle by:

  • Explicitly requesting its removal using the C line command online
  • Specifying the CLEAN option when starting the CA View started task.