Using the Optical Disk Interface › Configuring the Optical Disk Interface › Step 4: (Optional) Customize Optical Migration Scheduling › Scheduling Parameters: DSK2MIGD

Scheduling Parameters: DSK2MIGD

The DSK2MIGD specifies the type of optical migration that is to occur on each day of the week beginning with Monday. The syntax is as follows:

Syntax:

DSK2MIGD=xxxxxxx

where:

A

Specifies automatic scheduling.

Migration occurs during the time set by DSK2TIME.

Note: The optical migration subtask scans the database intelligently (not a repeat full pass each time), so processing time is minimized.

If a time range that is specified by DSK2TIME goes past midnight (for example, Friday 11 p.m. to 2 a.m. Saturday), only the day that the range begins (Friday) must be specified with an A.

M

Specifies that no automatic scheduling occurs.

Optical migration occurs when it is manually requested, through the operator commands.

B

Specifies that optical migration is performed by the CA View standard backup cycle.

Note: This option only migrates reports created in the current generation. If you reindex or manually mark an OPTICAL report from a previous generation, it remains on disk until you run SARDSK2B.

N

Specifies that no backup migration is to occur.

Backup does not occur even if operator commands to start up the optical migration task are issued .

This option is provided so that you can be certain that no optical migration can occur during a specific time.

The default is BBBBBBB.