Previous Topic: D2RETPD:Next Topic: Step 1: Specify the Optical Disk Storage Driver

Using the Optical Disk Interface › Configuring the Optical Disk Interface › Overview of Configuration Steps

Overview of Configuration Steps

This section presents an overview of the process you must use to configure CA View to use the optical disk interface. These steps are explained in the sections that follow.

  1. Use the DSK2DRVR SARINIT initialization parameter to specify which optical disk driver you are using.
  2. Use the DKS2PARM SARINIT initialization parameter to specify the page‑level drivers.
  3. Set optical migration options in the ERO table (with disk and tape migration options), using the following keywords: 
    DSK2DAYS
DSK2NOTP
  4. Customize optical migration scheduling with the following initialization parameters: 
    DSK2MIGD
DSK2TIME
DSK2INTV

    Note: By default, the CA View backup cycle performs all optical migration.

  5. Run SARINIT to implement your initialization parameter settings to the database.