This parameter specifies the time interval in hours and minutes after which the backup cycle is automatically initiated. A value of 0000 is converted to the default of 2400, which is the maximum value for this parameter.
Syntax:
INTERVAL=hhmm
The default is 2400.
Values are as follows:
The hour, based on a 24-hour clock.
The minutes.
Valid values for hh are 00-24. Valid values for mm are 00-59.
The maximum value that can be specified is 2400 (the default).
Note: For more information about this parameter, see the TIME command later in this chapter.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|