Starting Your Product › How to Configure Without CA CSM › Step 19: Use SARINIT to Set the Final Initialization Parameter Values

Step 19: Use SARINIT to Set the Final Initialization Parameter Values

All users must perform this step.

Upgrade Considerations

For more information about upgrading and information that applies to this step, see the chapter Migration Information.

General Considerations for All Users

The SARINIT program is used to inspect, set, or change database initialization parameters. For complete instructions and a discussion of the parameters available, see the chapter "Initialization Parameters" in the Reference Guide.

Review the Initialization Parameter Worksheet

Review all of the parameters on your Initialization Parameter Worksheet. Verify that all options have been appropriately set.

Note: Any parameter that you do not modify is set to its default value.

Run SARINIT

Use the following procedure to run SARINIT. Sample JCL for this job is provided in member SARINIT of CAI.CVDEJCL.

1. Create the SARINIT control statements using the Initialization Parameter Worksheet in the appendix "Installation Worksheets."
2. Run SARINIT.
3. Save this JCL and control statements.

Note: You can run SARINIT again to change particular options.