Printing Output › Online and Batch Printing—P and J Commands › Using the P and J Commands › SAR Mode › J Command

J Command

When you use the J command in SAR mode, a batch job is created to print the output you specify.

Note: The job is submitted when you exit the product or issue the SUBMIT command.

1. In the Sysout Selection List, enter J in the Select column of the output you want to print, and then press Enter to display the Primary Print Attribute panel.
2. Do one of the following in the Primary Print Attribute panel:
   • To print from this panel, press Enter.

     The output is queued for printing.

   • To print on an alternate optional printer, enter A on the command line, then press Enter to display the Alternate Print Attribute (optional) panel.
3. In the Alternate Print Attribute (optional) panel, press Enter to queue the output for printing.
4. Do one of the following to submit the batch print job:
   • Issue the SUBMIT command.
   • Exit CA View.
5. When the Batch Card JCL panel appears, verify the JOB statement information.