Printing Output › Online and Batch Printing—P and J Commands › Using the P and J Commands › EXPO Mode › J Command

J Command

When you use the J command in EXPO mode, a batch job is created to print the output you specify.

Note: The job is submitted when you exit the product or issue the SUBMIT command.

1. In the Report Selection List, enter J in the Select column of the output you want to print, then press Enter to display the main CA Deliver Reprint Attribute panel.

   Note: For more information about this panel, see Main CA Deliver Reprint Attribute Panel.

2. Verify/change the print attributes in the main CA Deliver Reprint Attribute panel, then do one of the following:
   • If you want to print from this panel, press Enter to queue the output for printing.
   • If you want to print from an optional printer panel, go to Step 3.
3. In the main CA Deliver Reprint Attribute panel, do one of the following:
   • To print on the primary optional printer, enter P on the command line, press Enter to display the primary printer panel, and then go to Step 4.
   • To print on the alternate optional printer, enter A on the command line, press Enter to display the alternate printer panel, and then go to Step 5.
4. In the primary printer panel, press Enter to queue the output for printing.
5. In the alternate printer panel, press Enter to queue the output for printing.
6. Do one of the following to submit the batch print job:
   • Issue the SUBMIT command.
   • Exit CA View.
7. When the Batch Card JCL panel appears, verify the JOB statement information.