

Operator Commands › Setting an Initialization Parameter While CA Deliver Is Running › Initialization Parameter Considerations
Initialization Parameter Considerations
Be aware of the following:
- You cannot set any initialization parameters that are not included in the previous list. Initialization parameters and their operands are listed alphabetically in the chapter "Initialization Parameters."
- You must set the SETCMD initialization parameter to YES before this operator command can work.
- If you change the setting of the TIME initialization parameter, you will cause a recalculation of the daily cycle start time. This can impact the running of the daily cycle.
Copyright © 2013 CA.
All rights reserved.
 
|
|