Inquiry Function › Clean up and Reconnect Sessions

Clean up and Reconnect Sessions

To clean up a session started at a terminal that is no longer available, type C to the left of that function and press Enter. However:

• For Run functions, the CICS task must be terminated before cleanup.
• For Browse functions, cleanup is allowed if the terminal is disconnected; use Reconnect if the terminal is active.
• For Utility functions, cleanup is allowed if the terminal is disconnected; use Reconnect if the terminal is active.
• For Log functions, cleanup is allowed if the terminal is disconnected; use Stop if the terminal is active.

Note: CA Verify for CICS will determine whether cleanup is necessary. If it is not necessary, only the alternate function (Stop or Reconnect) will be allowed.

To reconnect a session left on a terminal, type R to the left of that function and press Enter. After you specify Reconnect, pressing Enter at the terminal which owned the session may redisplay the Primary Options Menu.

Reconnect cannot be specified for:

• Run functions, unless the run has not yet begun or has completed
• Transactions, which have been purged or have abended

Use Cleanup instead of Reconnect in these situations.