INPUT TEST STREAM NAME:
DDNAME, APPLICATION, MEMBER, VERSION
Fill in the name of the test stream you logged.
Specifies the name of the new test stream. Typing an asterisk in the DDNAME field instructs CA Verify for VTAM to generate a name automatically. This name will be the same as the original name with the Version incremented to the next version available.
Type * in the DDNAME field.
Specifies whether rules should be applied during the run.
Leave Y as the default.
Specifies the type of comparison: screen, logical, or physical.
Leave S as the default.
Specifies whether or not CA Verify for VTAM should store any history information it detects. If stored, this information can later be viewed or printed.
Leave Y as the default.
Specifies whether or not the operator must explain each mismatch.
Leave N as the default.
Specifies the rate at which input screens are sent to the application, simulating user think time.
Leave NONE as the default.
Specifies, in seconds, how often CA Verify for VTAM should report the status of the run.
Leave 005 as the default.
Specifies, in minutes, how often CA Verify for VTAM should give you the opportunity to cancel the run.
Leave 001 as the default.
Specifies whether the run should be interrupted if a mismatch is encountered.
Leave Y as the default.
|
Copyright © 2012 CA.
All rights reserved.
|
|