Installation Verification Procedure and Demo Session › Specify Single Terminal Log Options › Field Definitions

Field Definitions

LOG TEST STREAM AS:

DDNAME, APPLICATION, MEMBER, VERSION

Identifies the test stream.

• The ddname is the data set into which the screens will be logged. Your installation may have many valid ddnames. TCADS is the default and should be available. However, you can tab to this field and overtype it if necessary.
• The Application and Member are the names you specify for the test stream.
  • Tab to the Application field and type demo.
  • Then tab to the Member field and type demoprog.
• The Version identifies the test stream when multiple test streams have the same DDname, Application, and Member names. Leave 001 as the default.

DESCRIPTION

Describes the test stream.

Tab to this field and type any meaningful text, using up to three lines.

STOP OPTION

Specifies how you will terminate logging.

Leave DISC as the default. Logging will end when you disconnect from the VTAM session. You can also specify a PF or PA key, CLEAR, or MAN to manually stop logging.

PROCESS WITH RULES

Specifies whether Rules should be applied to this logging session.

Leave N as the default.

TEST STREAM PROTECTION

Limits access to this test stream by other users.

Leave this field blank.

LOG INPUT SCREENS ONLY

Logs only input screens from the terminal to the application.

Leave N as the default.

EXTEND TEST STREAM

Specifies whether or not this test stream is to be appended to an existing test stream.

Leave N as the default.

VIRTUAL TERMINAL

Assigns a specific virtual terminal to the real terminal.

Leave this field blank.