Utilities › Merge Terminals into a Test Stream › Select Terminals

Select Terminals

If the test stream to be merged is a multiple terminal test stream, CA Verify for VTAM displays the Terminal Selection menu. See the section Copy a Test Stream for a description of this menu.

Follow these steps:

1. Type S to the left of each terminal you want to select and use the End (PF3) command. You must select at least one terminal.
2. Type in I to the left of each terminal for which you want to view Initial Terminal Status information and press Enter. See the the "Browse Function" chapter for an explanation of the Initial Terminal Status menu. When you exit from the Initial Terminal Status menu, CA Verify for VTAM redisplays the Terminal Selection menu.
3. Use CA Verify for VTAM commands as follows:

   Assign

   Insert S to the left of every terminal

   Reset

   Insert _ (the initial setting) to the left of every terminal

   Up (PF7) and Down (PF8)

   View additional terminals which don't appear on the initial menu

   Cancel

   Cancel the merge