Important! Do not use this procedure the first time you mount a bin tape. This procedure is for tapes that have already been entered in the Bin system. If this is the first time you are mounting this tape, see Entering a Tape Into the Bin System for instructions on first entering this tape into the Bin system.
Bin system users mount a bin tape the same way they mount a regular tape, specifying the bin or slot number instead of the volser. For example, to mount the tape in bin BN0025, enter:
vmtape mount bn0025 (nowait
Note: For information about the MOUNT command, see the Command Reference Guide.
CA VM:Tape requests the operator to mount the volume and specifies the bin number as the volser. When the volume is mounted, CA VM:Tape reads the internal VOL1 label and compares the result to the internal VOL1 serial number stored in the INTVS field as part of the user accounting area.
If there is no VOL1 label, CA VM:Tape asks the operator to enter the bin number for verification, as in standard CA VM:Tape NL (non-labeled) processing. The tape mount is accepted or rejected according to the validation by the operator.
|
Copyright © 2013 CA.
All rights reserved.
|
|