Host Specific Settings

Host Name

hostname for this CA Enterprise Log Manager server

For example:

CA-ELM1

Specify the host name for this server using only supported characters for hosts. Industry standards recommend A-Z (case-insensitive), 0-9, and hyphen, where the first character is a letter and the final character is alphanumeric. Do not use the underscore character in a host name, or append a domain name to this host.

Note: The host name must not exceed 15 characters.

Root Password

new root password

Create and confirm a new root password for this server.

IP Address

relevant IPv4 address

Enter a valid IP address for this server.

Subnet Mask

relevant IP address

Enter a valid subnet mask for use with this server.

Default Gateway

relevant IP address

Enter a valid default gateway for use with this server.

DNS Servers

relevant IPv4 addresses

Enter one or more DNS server IP addresses in use in your network.

The list is comma-separated with no spaces between entries.

If your DNS servers use IPv6 addressing, enter these addresses in that format.

Domain Name

your domain name

Enter the qualified domain name in which this server operates, for example, mycompany.com.

Note: The domain name must be registered with the Domain Name Server (DNS) server in your network to enable resolution of the hostname to IP address.

EULA

Accept

Read through the CA license agreement, paging down until you reach the question, Click on Accept to Accept the agreement.

Time Zone

your desired time zone

Select the time zone where this server resides.

NTP Server Location

relevant hostname or IP address

Enter the host name or the valid IP address of the NTP server from which the CA User Activity Reporting Module server gets date and time information.

Application Specific Settings

Location of CA EEM Server

Local - for the first installed server (management server)

Remote - for each additional server

Indicate whether you plan to use a local or a remote CA EEM server.

For a management CA User Activity Reporting Module server, choose Local. The installation prompts you to create a password for the default EiamAdmin user account.

For each additional server, choose Remote. The installation prompts you for the management server name.

Regardless of whether you chose local or remote, you must use the EiamAdmin account ID and password to log on to each CA User Activity Reporting Module server the first-time.

Host Name or IP Address of the remote CA EEM Server

IP address or hostname

Enter this value only if you select Remote in the Local or Remote server option.

Enter the IP address or host name of the management CA User Activity Reporting Module server that you installed first.

The host name must be registered with the DNS Server.

If you want to use a local CA EEM server, the default value is none.

Password for CA EEM Server

EiamAdmin account password

Record the password for the default administrator account, EiamAdmin.

Your CA User Activity Reporting Module server requires these account credentials for the initial login.

If you are installing the management server, you are creating and confirming a new EiamAdmin password here.

Make a note of this password as you must use it during the installations of other CA User Activity Reporting Module servers and agents.

Note: The password you enter here is also the initial password for the default caelmadmin account that you use to access the CA User Activity Reporting Module server directly through ssh.

You can create additional administrator accounts to access the CA EEM functions after installation, if desired.

FIPS

Yes or No

Specifies if the virtual appliance must run in FIPS mode or non-FIPS mode. If you choose to use a local CA EEM server, you can choose any mode. If you choose to use a remote CA EEM server, you must choose the mode that the remote CA EEM server uses.