When you install an agent or create a response file on a Solaris system, you specify values for the five parameters listed on the following table. If you copy this file for reuse on other systems, you can edit the original values as needed, or if appropriate, use the original values.
To edit the response file
|
Field |
Description |
|---|---|
|
ELM_SERVER |
The Host name or IP address of the CA User Activity Reporting Module server. Enter the host name if the CA User Activity Reporting Module server gets its IP address dynamically through DHCP. |
|
BASEDIR |
The full path to the agent root directory. Default: /opt/CA/ELMAgent. |
|
AUTH_CODE |
The Agent Authentication Key. Select the Agent Authentication Key button in the Agent Explorer under Administration to view or set this key. Note: If the key value you enter during installation does not match the entry in the UI, the agent service will not start after installation. |
|
FIPSMODE |
Indicates if the Agent runs in FIPS mode. Default: OFF |
|
AGENT_USER |
The user name for running the CA User Activity Reporting Module agent. We recommend that you create a lower-privilege user account to run the agent before starting the agent installation. Default: root |
|
DEFAULT_CONNECTORS |
The exported file containing connector configurations, including the path. Leave this field blank if the Connectors.xml file is not available. Default: <blank> |
|
Copyright © 2013 CA.
All rights reserved.
|
|