Using the TSSSIM Utility › TSSSIM Special Commands

TSSSIM Special Commands

The special simulator commands perform no resource checks. They provide the administrator with information about the simulator within CA Top Secret.

EJECT Command—Page Eject

Use this batch‑only command to cause a page eject before the next command is executed by the simulator.

Note: These commands are entered as control statements in the JCL when executing TSSSIM in batch. For information, see Using TSSSIM/Batch.

STATUS Command—Current Environment's Status

Use this command to provide the current status of the simulation environment:

• Simulation ACID, data set qualifier, simulation mode
• Simulation facility, terminal, CPU
• Default SVC name, SVC number, and associated access
• Default privileged program PRIVPGM
• Default TRACE setting

Example: STATUS command

This example views the current status of the logged on simulated ACID:

STATU

TSS Command—Performing Security Administration Functions

This command is not executed by the simulator. It is passed on to the CA Top Secret administration processor module. All of the administration command functions are supported. This gives the administrator the capability of performing any security administration function without the need to leave, and then subsequently re‑enter the simulator.

This command uses TSS command functions and parameters.

Example: TSS command

This example views information on a profile:

TSS LIST(SYSPROF1) DATA(ALL)