Reason:
If CA Top Secret was started before JES, the JES option must be specified, indicating both TYPE and LEVEL in the parameter file.
At the time of job submission, the offsets for JCTINDEV, JCTROUTE, JCTNJHDR were set incorrectly.
An exit or OEM product has modified the JCT control block or a copy of this control block. The modified storage has been passed to CA Top Secret during job submission. In particular:
Module TSSMNJ2T must be the first program in line for JES2 exit 24
The CA Top Secret Installation Exit TSSINSTX may have to be modified if you employ the PRE‑INIT or POST‑INIT exit points to modify the JES control blocks.
The release of JES you have installed on your system is not supported by the current release of CA Top Secret.
Action:
Edit the parameter file so that the JES control option is correctly specified. Reinitialize CA Top Secret.
Unless your site makes modification to standard JES control blocks, you should allow the JCT control option to default. If your site makes use of standard offsets, this message can be caused by incorrect settings for the following parameters in the JES control option:
Make sure that all of these parameters correctly correspond to your implementation of JES on this system. When these have been corrected, you may or may not need to resubmit the job.
Determine whether an inhouse exit or an OEM product could be modifying the JCT passed to CA Top Secret. Consult the documentation for your exit or the OEM product to assure it is properly installed with macros corresponding to your operating system. If the JCT has been modified as designed, assure that the JCT offsets in the CA Top Secret JCT control option corrected to correspond with this design.
Contact CA Top Secret Support.
|
Copyright © 2014 CA Technologies.
All rights reserved.
|
|