Installing Your Product from Tape › How to Install Products Using Native SMP/E JCL › Prepare the SMP/E Environment for Tape Installation

Prepare the SMP/E Environment for Tape Installation

The members that are used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA Top Secret.

For information about the members, see the comments in the JCL.

Follow these steps:

1. Customize the macro TSSSEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE command. Each time that you edit an installation member, type TSSSEDIT on the command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize your yourHLQ.SAMPJCL members.

   Note: The following steps include instructions to execute the TSSSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the TSSEDALL member.

2. Open the SAMPJCL member TSS1ALL in an edit session and execute the TSSSEDIT macro from the command line.

   TSS1ALL is customized.

3. Submit TSS1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA Top Secret are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. Open the SAMPJCL member TSS2CSI in an edit session and execute the TSSSEDIT macro from the command line.

   TSS2CSI is customized.

5. Submit TSS2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.