Previous Topic: Check Authorization to Run the Unload UtilityNext Topic: JCL Requirements

Unloading the Security Information › Run the Unload Utility

Run the Unload Utility

The CIAUNLD job executes the unload utility, which reads the security information from the security database and creates an unload data set. This unload data set is used as input to the load process.

Note: A number of control statements exist to control the processing of the unload utility. These statements can be specified as input to the SYSIN input data set.

To run the unload utility

  1. Edit the CIAUNLD job in CAI.CAK0JCL0.

    Specify the unload data set allocated earlier and any control statements that you require to conform to the standards of your site.

  2. Submit the job.
  3. Check the output of the CIAUNLD job.

    Verify that the utility completed successfully. If the CIAUNLD job fails for any reason, you must rerun the job until it successfully completes; otherwise the UNLOAD data set cannot be properly loaded to the relational database and enhanced compliance reporting capabilities will not be available.

For more information, see JCL Requirements and Control Statements.

More Information:

Control Statements