The following pages show the text of these user messages, their meaning, and how you should respond to them.
Note: Messages are presented in alphabetical order.
Reason:
The product issues this message if your attempt to activate an application session fails because the application is unavailable.
Action:
Check for application availability and try again.
Reason:
This message indicates that you have tried to activate a virtual terminal session, but the product does not have a virtual terminal for your use. Once a virtual terminal is available, the session is activated. However, the product may not be able to activate a session if it cannot find any available virtual terminals that satisfy model or naming requirements, or if all available virtual terminals for the application are already occupied.
Action:
Wait for a few minutes, and then try again. If the problem persists, consult your administrator.
Reason:
A session was started in PASS mode and ended normally.
Action:
None
Reason:
A requested session in PASS mode could not be established.
Action:
Consult your administrator. The TPXL0051 message in the Log will have further information about the session setup failure.
Reason:
An application has terminated or is unavailable. The product issues this message when an application terminates for one of the following reasons:
Action:
Wait for a few minutes, and then try again.
Reason:
This message indicates that you attempted to view a session containing graphics but your terminal is unable to display graphics.
Action:
Press PF3 or PF4 to select another session to view.
Reason:
The VTAM actions required to establish and terminate a session in PASS mode occurred in an abnormal sequence.
Action:
Ignore this message unless you subsequently experience difficulty starting sessions or if you log off the product and cannot get back on. In that case, see your administrator.
|
Copyright © 2013 CA.
All rights reserved.
|
|