Format of Operator Commands

When issued from the system console, Operator commands must have the following format:

F tpxname,command operand,operand...

where:

tpxname: Specifies the name of the startup procedure.
command: Specifies one of the operator commands, described in the chapter Operator Commands.
operand: Specifies a valid operand for the command. Operands define and limit command action and pass control information to the command processor. They are separated from the command by a space and from each other by a comma. Each command's operators are described with the command in the chapter Operator Commands.

When issued in an Operator session, operator commands have the following format:

command operand,operand...

Important! Do not use the F tpxname command when issuing commands in an Operator session.