Abend Codes › Abend Codes

Abend Codes

U0001

Reason:

An error condition has been detected during initialization.

Action:

See the associated console message for more information.

U0002

Reason:

A mismatch has been detected between a module and the System Options Table (SMRT). Some modules from an earlier release may have been inadvertently accessed.

Action:

Correct the error and restart the product.

U0003

Reason:

The product has run out of internal save areas.

Action:

Count the number of TPXL0048 SAVE AREA EXPANSION messages. If there are less than 50, increase the region size and SMRT system storage and tune the below-the-line storage. Otherwise, contact CA Technical Support.

U0007

Reason:

An error has occurred in POST logic. The operating system has rejected the software request to post an ECB.

Action:

Contact CA Technical Support.

U0031

Reason:

A request has been made for more than the maximum allowed storage.

Action:

Contact CA Technical Support.

U0032

Reason:

The product has been unable to satisfy a storage request. At the time of the ABEND, register 2 contains the size of the storage request. If register 12 contains an X'80' in the high order bit, the request was for the above-the-line storage.

Action:

Gather the following information and contact CA Technical Support:

• Storage parameters for the System Options Table (SMRT)
• Recent D STOR and D STORXA displays from a TPXOPER session
• The SYS1.DUMP data set produced by the abend.
• The TPX started task log, including LOG file.

U0100

Reason:

Authorization code verification has failed.

Action:

Contact CA Technical Support.

U0503

Reason:

The product has not successfully opened the ADMIN2 file and therefore has been unable to process signon requests.

Action:

See the associated system console message, TPB126 or TPX126.

Unnnn

Reason:

An internal logic error has been detected.

Action:

Save the resulting dump and the Log and contact CA Technical Support.

S106-F

Reason:

You tried to start a component or components without enough storage to load modules during initialization. You must have a region of at least four megabytes.

Action:

Adjust the region size as necessary.

S878-10

S80A

S804

S40D

Reason:

These messages indicate that the software has been unable to obtain system storage.

Action:

Increase the region size and the SMRT system storage value.

Sxxx

Reason:

If an unrecoverable subtask abend has occurred, the main task abends with the same abend code as the failed subtask. The software also issues message TPB021 or TPX021.

Action:

Save the resulting dump and the Log and contact CA Technical Support.