Starting Your Product › Log On a Terminal to CA TPX

Log On a Terminal to CA TPX

When you have started the product, establish a connection between it and your terminal by issuing the command:

LOGON APPLID(TPX)

Note: The command you issue can have a different format if the VTAM system programmer at your site has altered the distributed Unformatted System Services (USS).

The USS component of VTAM converts this command to a request to initiate the application. VTAM honors this request as long as you have done both of the following:

• Defined a primary logical unit (PLU) named TPX on an APPL statement in the SYS1.VTAMLST data set.
• Activated the product by issuing the console commands specified in the section Starting CA TPX.

If using the TCPaccess Telnet Server interface, the 3270 emulator settings must specify the host IP address and port assigned to CA TPX in the Server. When the IP session is established, the user will see the TPX logon screen.