Usually, an ACL/E program will reach a STOP command and terminate. However, if a program "hangs" or goes into an endless loop, you can stop it by typing the following command and then pressing the command key:
/V
When using a non-SNA terminal (or emulator) and the keyboard is locked, you must press the Reset key to unlock the keyboard so that you can type the command. When using an SNA terminal (or emulator) and the keyboard is locked, you must press the Attn key, which takes you back to the menu from where you can issue the STOP command.
|
Copyright © 2013 CA.
All rights reserved.
|
|