Specifying Application Characteristics › Add or Select an Application Characteristics Table

Add or Select an Application Characteristics Table

Create an Application Characteristics Table for your system before you define application characteristics.

To add or select an Application Characteristics Table

1. From the TPX Administration Menu, select option 2, TPX System Options.

   The TPX System Administration Menu is displayed.

2. Select option 2, Application Definition (ACT).

   The TPX Application Characteristics Table List is displayed.

3. Do one of the following:
   • To add a table, type S table-name on the command line, where table-name is the name of the table you want to add or select. Then press Enter.
   • To select an existing table, either type S table-name as described previously, or use the Tab key to move the cursor to the table you want, type S, and press Enter.

   The TPX Application Characteristics Table Entry List is displayed, as shown in step 2.

   If you want the product to use this table at startup, you must specify the table name in your startup procedure, as explained in the Installation Guide.

   In the following panel, the administrator is adding an Application Characteristics Table named SYSBTEST.

              TPX Application Characteristics Table List 
                                                          Panelid - TEN0091 
   Command ===> S SYSBTEST                                Userid  - SYSADMIN
                                                          Termid  - DXAP59B 
     Application                                          Date    - 07/14/03
     Characteristics                                      Time    - 07:40:05
     Table             Last Updated by   Userid 
     SYSAPROD          07/03/03 13:19:11 SYSADMIN STARTUP 
   ******************************* BOTTOM OF DATA **************************