The purpose of the Common Tape System (CTS) is to provide a set of interfaces to all CA Tape Management products. CTS consists of a started task, utilities, and interface programs. CTS is started from SYS1.PROCLIB(CTS). During startup it reads commands from the CTSSYSIN DD which is CAI.CTAPOPTN(CTSSTART) by default. This section contains a discussion of those commands.
Note: This chapter includes CTS subtasks that are used by general users of CA TLMS. CTS supports additional subtasks that are configured and maintained by the systems programming staff. These subtasks are documented in the Configuration Guide.
|
Copyright © 2014 CA.
All rights reserved.
|
|