Using the Tape Retention System (TRS) › TRS Processing Considerations › RUNDATE

RUNDATE

Using the following SYSIN control statement, a date (other than the current date) can be specified to cause the results to appear as though TRS has been executed on the date supplied:

RUNDATE=mm/dd/yyyy,ACCEPT

where mm/dd/yyyy is the date desired. Processing applies only to types 2, 3, 5, 8, B and C. The ACCEPT operand is required only if the date is three or more days from the current date. This date is reflected on reports TLMS042, TLMS043, and TLMS044. The RUNDATE statement must precede the TLMS044 statement.

Note: It is recommended that you perform a forecast run after making changes to the RMF. It can be used to verify that your changes have affected only the applicable data sets.