Installing Your Product from Tape › How to Install Products Using Native SMP/E JCL › Prepare the SMP/E Environment for Tape Installation

Prepare the SMP/E Environment for Tape Installation

The members that are used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA TLMS.

For information about the members, see the comments in the JCL.

Follow these steps:

1. Customize the macro TLMSEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE command. Each time that you edit an installation member, type TLMSEDIT on the command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize your yourHLQ.SAMPJCL members.

   Note: The following steps include instructions to execute the TLMSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the TLMEDALL member.

2. Open the SAMPJCL member TLM1ALL in an edit session and execute the TLMSEDIT macro from the command line.

   TLM1ALL is customized.

3. Submit TLM1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA TLMS are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. Open the SAMPJCL member TLM2CSI in an edit session and execute the TLMSEDIT macro from the command line.

   TLM2CSI is customized.

5. Submit TLM2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.