Use the VMFNAM system option to specify the name of the VMF. This name is used to verify that batch programs are processing the active VMF. This value is overridden by the data set name in the CTS JCL when CA TLMS is started. This entry should be omitted unless needed. This parameter is only needed to run CA TLMS programs after TLMSRIM has run but before CA TLMS is started under CTS.
This system option has the following format:
VMFNAM=dsn
Specifies the fully qualified data set name of the VMF
Example: VMFNAM System Option
VMFNAM=CAI.TLMS.VMF
|
Copyright © 2014 CA.
All rights reserved.
|
|