User Views › Object Menu Bar › Operate Menu › Selecting an Object Mode › Mode Defaults
Mode Defaults
If you display an object without specifying a mode, the host assigns a default mode based on the following tests. Once a default is assigned, the remaining tests are skipped.
- If SC is valid, then it is the default.
- If LI is valid, then it is the default.
- If DC is valid, and its Disk Checkpoint data set exists, then DC is the default.
- If DC is valid, but its Disk Checkpoint data set does not exist, then RT is the default.
- If DI is valid, then it is the default.
- If RT is valid, then it is the default.
- If Log is valid, then it is the default.
Note: The Capture (Cap) mode is never assigned as the default.
More Information
Selecting an Object Mode
Mode Validation
Mode - Zoom Rules
Copyright © 2013 CA.
All rights reserved.
|
|