When a CA Spool file becomes ready, a request is issued to the primary spooling system to see if the destination name is defined as a JES2 or JES3 destination. If so, the spool file is transferred using a spin-off data set, and the CA Spool destination name is used to form the JES2 or JES3 destination assigned to the SYSOUT data set.
CA Spool writes separation pages before and after each spool file transferred. The spool file is retained in the CA Spool for the installation-specified number of hours, and then purged.
The spin-off data sets are created by CA Spool, but the primary spooling system (JES2 or JES3) considers the SYSOUT data set to originate from ESF and therefore, carries the name ESF. This filename is not retained when the file is transferred from CA Spool to JES.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|