There are no special considerations before starting CA Spool. It can be started at any time after initialization of the JES2 or JES3 primary spooling system.
Similarly, if JES2, JES3, or ACF/VTAM are shut down, only the File Transfer Interface or the VTAM Interface are affected. All other parts of the CA Spool
system will continue to operate normally. These interfaces can then be reactivated later.
To make the CA Spool system fully operational, enter START esfstc, where esfstc is the name of your CA Spool task, from the system console.
To terminate CA Spool processing, enter STOP esfstc, where esfstc is the name of your CA Spool task, or use the one of the variations of the CA Spool SHUTDOWN command.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|