System HOLDDATA indicates data that is an in-stream part of the SYSMOD, informing you of special conditions. The following reasons are used with SYSTEM HOLDDATA for your product:
Indicates that you must perform special processing before or after you apply this SYSMOD.
Deletes the SYSMOD load module. You cannot reverse this type of SYSMOD with the SMP/E RESTORE command.
Indicates a dependency for this SYSMOD that you must externally verify.
Indicates a documentation change with this SYSMOD.
Indicates that this SYSMOD requires a hardware engineering change. An EC hold SYSMOD usually does not affect the product unless the EC is present on the hardware device.
Indicates that the SYSMOD must be installed in both the Active and Alternate Extended Recovery Facility Systems.
Code a BYPASS(HOLDSYS) operand on your APPLY command to install SYSMODs that have internal holds. Code the BYPASS(HOLDSYS) operand only after you have performed the required action, or if you are performing the action after the APPLY, if that is appropriate.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|