Messages › Call Interface Return Codes › Return Codes ESFWRIT

Return Codes ESFWRIT

The following table is a list of the return codes from ESFWRIT interface.

• ''—Two EBCDIC spaces mean successful completion of the write request.
• CE—File-control block validation error. The file-control block interface address in the parameter list is not valid or points to a control block not defining the requested file, or the file is not opened by the calling task.
• IU—Privileged task has obtained control of the requested file's control blocks.
• NA—CA Spool interface is not active.
• NO—File with requested file sequence number has not been opened.
• NS—No storage was available for interface control blocks.
• OL—Write request rejected because the output limit was exceeded.
• PE—One or more parameters in the caller's parameter list are in error.
• RC—Write request canceled by CA Spool; this usually means that CA Spool has terminated abnormally.
• SS—Chain error detected locating the subsystem vector table (SSVT) set by AESFINTR/AESFPRIV.
• UE—The request has been rejected by the interface unit.
• 01—Write request rejected because the file with the specified file sequence number could not be located.
• 02—Write request rejected because mismatching filenames were detected; notify your systems programmer.
• 03—Write request rejected; mismatching file destination names detected.
• 04—Write request rejected because file was not opened for output processing.
• 05—Write request rejected; this status code indicates a logical error in the interface program. Notify your systems programmer.
• 06—Write request rejected because an invalid data set identification key has been detected in a spool block.
• 07—Write request rejected because no more spool available; record discarded.
• 08—Write rejected; file busy on another system in MAS configuration.