

Messages › Call Interface Return Codes › Return Codes ESFCOMI
Return Codes ESFCOMI
The following table is a list of the return codes from the ESFCOMI interface.
- '—Two EBCDIC spaces indicate that the communication request has been successfully scheduled for execution.
- CE—Control block error. The CIB-address field in the caller's parameter list does not point to a valid CIB.
- CS—A communication end (CEND) has been scheduled during open processing; the channel has been closed down.
- IC—For an open request, the channel name in the caller's parameter list does not exist. For all other requests, the communication channel is in a closing state and does not accept new requests.
- IG—The specified communication channel cannot be used on an open-channel request with a channel-name code of R, N, or U because a non-zero network group is specified in the corresponding CID definition.
- IP—The channel password in the caller's parameter list is incorrect.
- IU—The communication channel is in use by another program.
- IZ—The communication channel is not started.
- NA—The communication interface is not active, and/or open requests are not permitted.
- NC—No communication channels have been defined in the CA Spool initialization parameters.
- NS—No storage was available for the interface control blocks.
- PE—One or more fields in the caller's parameter list is in error.
- QE—Queue empty; no responses or messages are currently pending
- RE—Request error; communication requests may not be issued from request-completion exit routines.
- RX—Maximum number of concurrent receive requests exceeded.
- SX—Maximum number of concurrent send requests exceeded.
- SS—Chain error detected locating the subsystem vector table (SSVT) set by AESFINTR/AESFPRIV.
- UE—Request rejected by the interface exit (ESFUSS).
- UG—The specified group number was not authorized for this user.
- IU—The user ID in the caller's parameter list does not exist.
Copyright © 2011 CA.
All rights reserved.
 
|
|