Installing Your Product from Tape › Prepare the SMP/E Environment for Tape Installation

Prepare the SMP/E Environment for Tape Installation

The members that are used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA Spool.

Before you begin this procedure, confirm whether your product uses UNIX System Services (USS). If it does, establishing a hierarchical file system (HFS) may be required as part of the product installation or required as a feature of the product.

For information about the members, see the comments in the JCL.

To prepare the SMP/E environment for your product

1. Customize the macro SPLSEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE macro command. Each time you edit an installation member, type SPLSEDIT on the TSO command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize your SPL.SAMPJCL members.

   Note: The following steps include instructions to execute the SPLSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the SPLEDALL member.

2. Open the SAMPJCL member SPL1ALL in an edit session and execute the SPLSEDIT macro from the command line.

   SPL1ALL is customized.

   Note: When upgrading into an existing CSI, comment out any allocation DD statements for existing files.

3. Submit SPL1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA Spool are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. If your product requires HFS or if you want to install a feature of the product that requires HFS, complete the following substeps:
   1. Open the SAMPJCL member BQ41ALLU in an edit session and execute the SPLSEDIT macro from the command line.

      BQ41ALLU is customized.

   2. Submit BQ41ALLU.

      This job allocates your HFS data sets.

   3. Open the SAMPJCL member BQ42MKD in an edit session and execute the SPLSEDIT macro from the command line.

      BQ42MKD is customized.

   4. Submit BQ42MKD.

      This job creates all directories and mounts the file system.

5. Open the SAMPJCL member SPL2CSI in an edit session and execute the SPLSEDIT macro from the command line.

   SPL2CSI is customized.

   Note: When upgrading into an existing CSI, comment out any allocation DD statements for existing files and delete the CREATCSI step. Change all ADD’s to REP’s.

6. Submit SPL2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.
7. If your product requires HFS or if you want to install a feature of the product that requires HFS, complete the following substeps:
   1. Open the SAMPJCL member BQ43CSIU in an edit session and execute the SPLSEDIT macro from the command line.

      BQ43CSIU is customized.

   2. Submit BQ43CSIU.

      This job customizes the CSI by adding the DDDEFs associated with the directory.