Changed Initialization Statements

The following initialization statements have been changed in Release 11.7:

DESTID

The following enhancement has been added:

New DCC and FCC to set a default CC attribute or force a CC attribute if A or M on any file.

NODE

The following enhancements have been added:

New X2YY=ccccccc parameter specifies that the transformation must be performed by the Transformer functional subsystem with the name cccccccc.
New VFC6 for nodes using the SMTP driver to add an extra linefeed at the end of each page in a .txt attachment.
New VFC7 for TCP/IP nodes to add new vertical form control sequence x’0D0A0C’. Line feed sequence X'0A' is used when VFC7 parameter is defined instead of default line feed sequence X'0D0A'.
New VPSOPT=23 to allow all blank lines written to an LU3 Virtual printer to be written into the resulting Spool file.
New TCPDRIV option - Automatic include of existing FCB, Form and Chars PCLLIB resource members before the actual print file, and the RESET member after the print file. Commands are entered in EBCDIC. An asterisk or blank in column 1 indicates a comment line. A blank terminates the command string on each line. Data after the first blank is ignored. DEVICE statements are supported. PCL and Non PCL commands can exist in the same PCLLIB member.

XEQOPT

The following XEQ processing option has been added:

28 - allows CICS applications to write files record lengths up to the size of the CA Spool BUFSIZE.
30 - sets the lrecl to the largest possible value that the BUFSIZE parameter will permit when the PRMODE for incoming files is blank or equal to LINE. That value is equal to the BUFSIZE minus the fixed portion of each Spool buffer that is used by CA Spool to store information about it's format and contents. This option takes precedence over XEQOPTs 9, 10, 13 and 14.

XFEROPT

The following XFER processing option has been added:

22 - set OUTDISP=HOLD outdisp=hold if XFEROPT=11 is also set.
23 - when the FORM name passed from JES to the SAPI interface is equal to the DEFFORM in the ESFPARM file, do not use that form name on the open request for the file. This allows either a DESTID or the NODE FORM parameter to provide the default FORM name. If no DESTID or NODE FORM is defined, the DEFFORM value will be used.

USEALIAS

The following USEALIAS option has been added:

ALL—In addition to the actions that are taken for USEALIAS=YES, CA Spool also uses the alias name of the printer in the CA Spool subtype 11 and JES type 6 SMF records.