Previous Topic: Set Up the Configuration Properties FileNext Topic: Log in to the Administrative UI

CA SiteMinder® Federation Standalone Installation and Upgrade Guide › Install CA SiteMinder® Federation Standalone › Unattended CA SiteMinder® Federation Standalone Configuration › Run the Unattended Configuration

Run the Unattended Configuration

You can configure CA SiteMinder® Federation Standalone without any user intervention.

Note: You must have previously configured a system manually to create the ca-Federation-config.properties file. You can modify this file to suit your network.

Follow these steps:

  1. From a system where CA SiteMinder® Federation Standalone is already installed, copy the following two files to a temporary location:
  2. Run the following command from where you copied the installation and properties files:

    configuration_executable -f ca-federation-config.properties -i silent

    The configuration starts in unattended mode, using the parameters in the properties file for settings.

  3. On Windows, reboot the system after the configuration is complete.

    Note: To verify an unattended installation on Windows review the installation log file CA_Federation_Standalone_Install_date_time.log, which is located in the directory federation_install_dir\install_config_info.