Web Services Security Guides › CA SiteMinder® Web Services Security Agent for Oracle WebLogic Guide › Install the SiteMinder WSS Agent for WebLogic on a UNIX System › How to Configure Agents and Register a System as a Trusted Host › Configure a SiteMinder WSS Agent and Register a Trusted Host

Configure a SiteMinder WSS Agent and Register a Trusted Host

You configure a SiteMinder WSS Agent and register the system that hosts it as a trusted host using the CA SiteMinder® Web Services Security Configuration Wizard.

Run the SiteMinder WSS Agent Configuration Program on UNIX or Linux Systems

You can configure your SiteMinder WSS Agents and register a trusted host immediately after installing the SiteMinder WSS Agent or at a later time; however, the host must be registered to communicate with the Policy Server.

Note: You only register the host once, not each time you install and configure a SiteMinder WSS Agent on your system.

These instructions are for GUI and Console Mode registration. The steps for the two modes are the same, with the following exceptions for Console mode:

• You may be instructed to select an option by entering a corresponding number for that option.
• You press Enter after each step to proceed through the process. The prompts should guide you through the process.
• All passwords that you enter are displayed in clear text. To workaround this issue, run the installation in GUI or unattended mode.

To configure Agents and register a trusted host

1. If necessary, start the Configuration Wizard as follows:
   1. Open a console window.
   2. Navigate to agent_home/install_config_info, where agent_home is the installed location of the SiteMinder WSS Agent.
   3. Enter one of the following commands:

      GUI Mode: ./ca-pep-config.bin

      Console Mode: ./ca-pep-config.bin -i console

   The Configuration Wizard starts.

2. Use gathered system and component information to configure the SiteMinder WSS Agent and register the host.

   Note: If you choose to configure multiple Agents, you can set the Register with same Policy Server option to register them all with the same Policy Server.

When the wizard completes, the host is registered and a host configuration file, SmHost.conf, is created in agent_home/config. You can modify this file.

agent_home

Is the installed location of the SiteMinder WSS Agent