Working with CA Catalyst Synchronization › How to Enable Maintenance Mode Synchronization › Enable Inbound to Connector Operations in the Connector

Enable Inbound to Connector Operations in the Connector

By default, inbound to connector operations are enabled in all connectors. Verify that operations are enabled only in the connectors for which you want to make changes in their domain managers.

Note: If you are performing maintenance mode synchronization, verify that each connector supports update operations on the IsInMaintenance property. Then you can verify inbound to connector operations. See the Connector Guide for each connector for a list of supported operations.

Follow these steps:

1. Access the CA SOI Dashboard.
2. Click the Administration tab.
3. Expand Connector Configuration and the connector server name and select a connector entry.

   Settings for that connector display.

4. Verify that IsRemotable is selected in the Connector Controls table, select the check box if it is not, and click Save.
5. Repeat Steps 3-4 for all connectors that you want to participate in a supported use case. You can also disable inbound to connector operations for connectors that you do not want to participate in a supported use case.