You can start and run the CA EEM installation on a supported operating environment.
Important! If you have an existing CA EEM installation that you can use to authenticate CA Technologies products, do not install CA EEM again. Instead, install the CA Technologies products and reference your existing CA EEM installation. However, you need a minimum of CA EEM r8.4 SP4 CR05 before integrating with CA SDM r12.9.
To install CA EEM
Note: You can skip this step in CA EEM 8.4 or later, but a warning appears saying that you cannot integrate CA SiteMinder and SAML.
Important! If your computer does not have an appropriate drive for the installation media, copy the media content to the computer on which you want to install CA SDM. Then, start the installation. For a remote installation over the network, you can share a drive or folder on the network, and then connect over the network to start the installation.
The Installation Menu appears.
Note: If the Installation Menu does not automatically appear, start the installation by double-clicking the setup.exe file, located at the root of the installation media.
CA EEM is installed and you can install other CA Technologies products.
Note: From CA SDM r12.9, both CA EEM 32-bit and 64-bit installers are shipped. On a 32-bit windows computer, CA EEM runs as a 32-bit application and on a 64-bit computer, CA EEM runs as a 64-bit application.
But if CA iTechnology iGateway is running as a 32-bit application on a 64-bit Windows computer, then CA EEM also runs as a 32-bit application.
|
Copyright © 2013 CA.
All rights reserved.
|
|